That's amazing! Thanks a lot!!!

WAIT, **** , I LEFT OUT THE R.
****

Uh, Here's the revised version.

cheers mate, I made the adjustment in paint, wasnt about to complain about a free banner. thanks for this

No problem mate

no thats not too much juice. I remember having to change strings once because I wasnt getting enough "heat" out of it though, I was using a PC power supply corsair 5something. I have a hot knife and hand held cutter now. is your setup stationary? like you're going to manipulate the foam around the wire instead of the other way around?

It'll be stationary, but I'm planning out a hand held one made from a flashlight as well.

I've heard that a constant of 2 amps is preferred, some people I've seen dumbed down 24 volts to 4 volts, another thing I was reading was 8 volts and 2 amps.

I'll be using it to make foam molds for aluminum casting some snare drums, so it needs inside cuts and I need something as fixed as possible. The hand held one will be for cutting out snare beds and angleing the edges to 45 degrees.

ah i see. yeah I use mine mostly for car projects, seats mostly. are you using a phone charger or something similar as your power?

You know how back in the 90's, you probably had a drawer filled with cords that look like this?

I figure it's the best way to have it plug into the wall without any extra resistors.